A new energy-efficient circulator pump for heating and air-conditioning applications, Evoplus Lite, has been launched by Dab Pumps Limited.
Suitable for use in both residential and commercial applications, in particular larger buildings, the wet rotor circulator pump is ideal for systems demanding efficiency, reliable performance and versatility.
Long-lasting, it requires no further attention post-installation outside of routine maintenance. Key to its versatility is a motor head which can be turned to three different positions to accommodate requirements of even the tightest spaces.
Simple installation
Evoplus Lite is installed in a few easy steps. With just one connector to plug in, this plug-and-play unit is easy and practical, even in systems where space is tight or in awkward replacement situations.
With a single button set-up, the installation interface is intuitive with an easily read seven-segment LED display, while its low-maintenance set up means once it’s up and running, you forget it’s even there.
Forward-thinking design
Evoplus Lite has been designed from the outset to be reliable. Increased separation between the motor and electronics results in better thermic insulation and safer use during air conditioning, when systems tend to be more prone to condensation.
Direct access to the motor shaft makes for easier maintenance; for example, releasing and optimised operation, enabling quick and easy venting.
Summer Mode
With the Summer Mode function, even if the circulator pump is not running, its electronics are active.
Every 25 hours, Evoplus Lite comes back on, circulating the water long enough to stop limescale residue building up, which could otherwise clog the system.
Choose your performance
You can also choose Evoplus Lite’s performance level.
The circulator pump’s electronics can vary motor rpm, and consequently absorbed power, to achieve up to six different performance levels (curves).
That way, Evoplus Lite’s setting will be matched extremely accurately to the system’s specific requirements.
Specification: Evoplus Lite
• Operating range: 2.0-12.5M3/h with head up to 12M
• Pump body connections available: G1”½ – G2” – Flanged DN32 – Flanged DN40
• Pumped liquid temperature range: From -20°C to +110°C
• Working pressure: 16 bar (1,600 kPa)
• Protection class: IP44
• Standard power input: Single-phase 1×220-240 V ~ 50/60 Hz
(Same specification as above applies to the Evoplus Lite San model, but with pump body connections of G 1”½ – Flanged DN32 – Flanged DN40.)
For more information contact:
Jonathan Taggart, Sales Manager, Ireland and Scotland
E: jonathan.taggart@dabpumps.com
T: +44(0)796 612 6309
T: +44 (0)333 777 5010










